Cut 5 passive lengths approx 1 meter, 1 worker (can be metallic) approx 3 meters and wind as pairs.
Using a small gold ring for a Christmas decoration, or a split ring for a key chain, pass the centre of each passive through the ring and then thread the bobbins though the loop, pull down evenly. Ensure threads are in the order you wish your stripes to run.
Pin to picking so that the bottom of the ring is touching the first pin.
Place the 1st pin and hang the worker over it.
Pins 1-2: cross, twist, cross all pairs, extra twist on worker pair, place pin.
Pins 3-6: cross, twist, cross, twist 1st pair,
cross, twist, cross centre 3 pairs,
twist worker pair only, cross, twist, cross, twist 5th pair,
extra twist on worker pair, place the pin.
Pins 7-10: cross, twist, cross, twist 1st pair, extra twist on worker pair,
cross, twist, cross centre 3 pairs,
2 twists worker pair only, cross, twist, cross, twist 5th pair,
extra twist on worker pair, place pin.
Pins 11-32: cross, twist, cross, twist 1st pair, 2 extra twists on worker pair only,
cross, twist, cross centre 3 pairs,
3 twists worker pair only, cross, twist, cross, twist 5th pair,
extra twist on worker pair, place pin.
Pins 33-35: cross, twist, cross, twist 1st pair, extra twist on worker pair,
cross, twist, cross centre 3 pairs,
2 twists on worker pair only, cross, twist, cross, twist 5th pair,
extra twist on worker pair, place pin.
Pins 36-38: cross, twist, cross, twist 1st pair,
cross, twist, cross centre 3 pairs,
twist worker pair only, cross, twist, cross, twist 5th pair,
extra twist on worker pair, place pin.
Pins 39-40: Cross, twist, cross all pairs, extra twist on worker pair, place pin.
Wrap worker around all passives 2 times, and then tie off with a reef knot (like the snake). Leave a fringe and trim all threads.
Good luck :)
No comments:
Post a Comment